Geeetech

so this firmware is from 2019, im sure it is out of testing. How is it working and what changes are there?

Has this yet to be figured out? here we are 4 yrs later and still so limited with the m201

Kactus thanks, while sometimes it is a little hard to follow, I can understand for the most part. But what I am confused about is that you told me to measure the extruder step and if need be change it to 1mm. I do understand the estep however you said you changed to 101 but your screen shows 9* some...

Measure again, compare it with the line you took earlier. If it's in a good position, you don't have to do anything. Otherwise, in the printer configuration change the number of steps to 1mm for the extruder motor.

Thanks. You didn't mention if that setting was the correct one. Is it the manual extruder speed

Thanks kaktus, would the stepper setting be the manual extruder speed?

Also I have firmware 1.0.0.4 I stalled...

Hi everyone, I finally have my M201 all setup and tested all axis to make sure it runs smoothly. I downloaded a simple sharks tooth file opened it in easyprint3d with all the following settings (see pics) when I slice it and print my filiment comes out at first like string then starts to blob up and...

So when I go to mount the extruders the holes pre drilled leave the bracket setting on a mount screw. Am I doing something wrong?

So building my M201 and the directions show the fan bolting onto the A1 with a fan cut out behind stepping motor on left side. Well mine doesn't have any cutouts or holes so where do I place fan?