Page 1 of 1
Luminated Print Head for Geeetech Latest Rostock Delta 301
Posted: Thu Mar 09, 2017 10:13 am
by Armstrong
There was no light designed in Rostock Delta 301, I had to use a small torch in order to observe my first few layer on the platform. I have now added 3 white LEDs surrounding the print extrude. The LED brackets are 3D printed. The LEDs are connected in serial and power supplied by 9V DC through a power regulator.
Re: Luminated Print Head for Geeetech Latest Rostock Delta 3
Posted: Tue Mar 14, 2017 1:45 pm
by bang
Great
Re: Luminated Print Head for Geeetech Latest Rostock Delta 3
Posted: Sat Jun 03, 2017 5:39 am
by Percy
Hi I love the lights but that is not why I am contacting you or trying to contact you. I bought my 301 two or three months ago but I have not managed to set it up! Yes apart from the head scratching my bed! Were did you find the proper setup instructions? I have tried the forum and the internet but I cant get mine setup. Could you please tell me how you managed to do it?
Cheers for now Percy
Re: Luminated Print Head for Geeetech Latest Rostock Delta 3
Posted: Sat Jun 03, 2017 8:41 am
by William
Re: Luminated Print Head for Geeetech Latest Rostock Delta 301
Posted: Thu Oct 11, 2018 4:11 pm
by RachelD
Just loved this. Thanks for sharing it here. I am new to this forum community and I get know earn knowledge I can say. Keep up the good work.
Re: Luminated Print Head for Geeetech Latest Rostock Delta 301
Posted: Thu Mar 07, 2019 3:26 pm
by rohanjoshi
Great Post! I have read it fully. This is a very inspiring article for me. Thank you so much.