Dual extruders wrong steps/speed
Posted: Wed Sep 30, 2020 2:31 pm
Hi everyone,
I'm having an issue with the extruders of my m201 color mixer.
The steppers motors are moving more than should be, at least one.
When I set the mix 50/50 and move 1 mm using the LCD knob one extruder moves 1 mm, about a 1/16 of a complete turn, but the other moves around 1/6 or more...
Already swap the cables, adjust pot voltage, swap drivers and reflashed firmware, but the problem persist and is related to the port of the extruder 1 in the mainboard.
The printed was assembly about 3 years and was stored without use, this are the first tune on this machine.
Any idea will be appreciated.
I'm having an issue with the extruders of my m201 color mixer.
The steppers motors are moving more than should be, at least one.
When I set the mix 50/50 and move 1 mm using the LCD knob one extruder moves 1 mm, about a 1/16 of a complete turn, but the other moves around 1/6 or more...
Already swap the cables, adjust pot voltage, swap drivers and reflashed firmware, but the problem persist and is related to the port of the extruder 1 in the mainboard.
The printed was assembly about 3 years and was stored without use, this are the first tune on this machine.
Any idea will be appreciated.