Geeetech

Hello, after all the recommendations for the calibration of the table, when printing is not possible to achieve a straight movement of the extruder. At the control points, the required clearance is provided, but in the intermediate positions the gap increases. Tell me it is possible to install this ...

Hello, at the press of big details, the direct walls which are on removal from the center are printed unevenly, a bend to the center. How to correct it?

Hey. After updating the Repeter Host to ver. 2.1.3 the printer stopped printing normally. There are always errors during the printing process. Print attempts from SD card results did not yield. Help me please.

At me everything has turned out, thanks for the help

I just tried to go too far the printer according to this instruction

here what occurs at a payment insertion what to do?

I have GTM32 pro payment +
6 A4988, tell where to download an insertion on the printer 3 in 1 with such payment. and that an insertion which I have found didn't manage to be established. and now the printer doesn't work.

hello, during the press temperature of an extruder changes by 15 degrees from established, prompt what to do

Whether there is a step-by-step instruction on an insertion the 3D printer a 3 in 1 sprout with a payment of management of control board GTM32 set. Arduino which I downloaded don't support such payment what to do? Also prompt where it is possible to download an insertion for this printer. Thanks

Whether there is a step-by-step instruction on an insertion the 3D printer a 3 in 1 sprout with a payment of management of control board GTM32 set. Arduino which I downloaded don't support such payment what to do? Also prompt where it is possible to download an insertion for this printer. Thanks