Search found 3 matches
- Sat Jul 05, 2014 8:35 am
- Forum: Open Hardware
- Topic: 10dof sensor stick itg3200 gyro
- Replies: 8
- Views: 17309
Re: 10dof sensor stick itg3200 gyro
I ran the code and only the values 8,1,6 are produced for x,y,z respectively as shown below in the attached screenshot. I have ran this code before. These values are constant regardless of the orientation of the imu. I appreciate the assistance in attempting to correct my problem. I will be expectin...
- Thu Jul 03, 2014 6:13 am
- Forum: Open Hardware
- Topic: 10dof sensor stick itg3200 gyro
- Replies: 8
- Views: 17309
Re: 10dof sensor stick itg3200 gyro
I have tried with all baud rates available in the serial monitor. I am using the Arduino Uno R3 and I have used multiple firmware, all of which are only unsuccessful in reading non-zero values from the gyro. The accelerometer, magnetometer and barometer appear to be fine. I would really like to just...
- Tue Jul 01, 2014 10:19 pm
- Forum: Open Hardware
- Topic: 10dof sensor stick itg3200 gyro
- Replies: 8
- Views: 17309
10dof sensor stick itg3200 gyro
I have recently purchased a 10dof sensor stick with the itg3200 gyro. The accelerometer, magnetometer and barometers produce outputs. However I cannot seem to read anything other than zeroes from the gyro. I have have found and used multiple code that reads from the gyro but still produce the same r...